安全认证

安全认证

NL产品通过全球各主要国家地区认证
例如:中国强制认证(CCC),韩国KC,日本PSE,欧洲,北美,南美等认证
以下是部分已有的各国安全认证及使用警告符号

  • Replace broken protective glass.
  • C mark, Croatia
  • 功率因素校正符号Symbol for Power Factor Correction (PFC)
  • 灯具与物体最小距离Minimum distance to lighted object.
  • China Compulsory
  • UL Recognized, Canada and Usa
  • 二类灯(双绝缘)Class-II, luminaire is double insulated.
  • KC mark, South Korea
  • 最高工作温度Rated maximum temperature at casing. or specified point
  • 三类灯具Class-III, luminaire input is protective low voltage.
  • PSE mark, Category B Japan
  • UL listed, Canada and Usa
  • 有限工作温度Luminaire with limited outer temperature.
  • PSE mark, Category A Japan
  • UL Classified, Canada and Usa
  • 适用安装在未知可燃性材料家具Suitable for installing on or in furniture made from materials with unknown flammability
  • 额定最高环境温度,TA未注明时正常为25℃ Rated maximum ambient temperature, If TA not stated at product then the normal TA is 25°C
  • 嵌入式灯具禁用绝缘物遮盖Recessed luminaire must not be covered with insulating material.
  • 故障安全隔离变压器Fail-safe separating transformer
  • ETL Approved, Canada and Usa
  • 嵌入式灯具禁止安装在易燃空间Recessed luminaire must not be installed in normally flammable spaces.
  • 短路保护变压器分离Short-circuit-proof separating transformer
  • ETL Classified, Canada and Usa
  • 不能安装在可燃表面Luminaire must not be installed to normally flammable surfaces.
  • 非短路安全变压器分离Non-short-circuit-proof separating transformer
  • S mark, Sweden and EU Intertek SEMKO
  • 室内灯具Luminaire intended for indoor use only.
  • 整流器安全隔离Safety isolating control gear
  • PCT mark, Russia
  • 适用保护罩灯泡的灯具Luminaire only to use with self-shielded lamp.
  • 短路安全保护Short-circuit-proof safety isolating transformer
  • 超低电压安全Safety Extra Low Voltage
  • WEEE symbol. Waste Electrical and Electronic Equipment Directive
  • 非短路安全隔离变压器Non-short-circuit-proof safety isolating transformer
  • 地线符号Symbol for grounding / earth
  • CE mark according to requirements of 2004/108/EC and 2006/95/EC
  • 外置式整流器Independent control gear
  • 灯具配有内置整流器可装在可燃的表面。 F标记表示新标准下的其他符号。Luminaire with built-in control gear intended to be installed at normally flammable surfaces. F mark has been replaced by other symbols in new standard.